User Tools

Site Tools


blog:hb_elevation_jackscrew_to_dish_lug_bush_lubrication

This is an old revision of the document!


Hb elevation jackscrew to dish lug bush lubrication

The cover plates were removed from the pin at the high end of the jack screw. A grease nipple was installed in each cover plate and a gasket placed between the cover plate and lug. The bolts were replaced with 3/8 UNC X 1 inch bolts made of stainless steel. The screw holes needed cleaning with a tap and RP7. Grease was pumped in to the grease nipple to fill the cavity near the ends of the pin.

You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/attic/blog/hb_elevation_jackscrew_to_dish_lug_bush_lubrication.1328072412.txt.gz · Last modified: 2012/02/01 05:00 (external edit)