User Tools

Site Tools


handover:aua016

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
handover:aua016 [2017/02/02 14:20]
Tiege McCarthy
handover:aua016 [2017/02/02 15:45] (current)
Tiege McCarthy
Line 22: Line 22:
   * 18:00 UT Exp started OK. First source ​ 0834-201. Antenna checks and fringe check not done, due to time constraints.   * 18:00 UT Exp started OK. First source ​ 0834-201. Antenna checks and fringe check not done, due to time constraints.
   * 07:35 UT Noticed that the met sensor is stuck - has been reporting the same value on weather checks since experiment start. Called Jamie - fixing in 30 mins. Unreliable weather data prior to fix (Bryn) (note: correct weather data is from 11:23 UT onward! -Tiege)   * 07:35 UT Noticed that the met sensor is stuck - has been reporting the same value on weather checks since experiment start. Called Jamie - fixing in 30 mins. Unreliable weather data prior to fix (Bryn) (note: correct weather data is from 11:23 UT onward! -Tiege)
 +  * 15:00 UT Attempted to switch module in between scans, unfortunately the new module was in read only mode (error: error m5 -900 bank is write protected) , called Jamie, he was able to fix it using "​mk5=protect=off"​ and "​mk5=reset=erase"​. BEWARE: If you are looking back at these handover notes after getting the same problem, I am assuming "​mk5=reset=erase"​ fully wipes the disk, make sure the disk is empty (not that this is likely to occur if the disk already has data written onto it) before going ahead. First scan on new module is 033-1521, however, only latter part of scan is valid. Missed scans are 033-1503 to 033-1517 inclusive. (Tiege)
    
 **Yarragadee 12m:** **Yarragadee 12m:**
/home/www/auscope/opswiki/data/pages/handover/aua016.txt · Last modified: 2017/02/02 15:45 by Tiege McCarthy