User Tools

Site Tools


handover:hob005

This is an old revision of the document!


HOB005

Setup was very ambiguous. Is there a wiki-page dedicated to this special setup?

Hobart 12m

AUST/normal setup procedures followed but SNP file wasn't/isn't downloaded with drudge. No .sum file either. Only noticed when attempted to start schedule got “ERROR bo -105 Error opening schedule file FMP ? FFF”. Called on-call person and emailed various. Issue remains unresolved.

Hobart 26m

As per notes on here: (http://auscope.phys.utas.edu.au/opswiki/doku.php?id=observing:hohb) the mk5 was swapped over. And schedule started. Initially got nominal response from mk5=dot? So started schedule. Got error “ERROR tc -302 TPICD not set-up: no detectors selected”. After observer and on-call person attempted to fix, status went from bad to worse and errors concerning wrong mode selected in equip.ctl file started. And disk_record=off no longer worked as “Error m5 -900: Can't record with Mark-5B DOM”. Also unresolved.

You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/attic/handover/hob005.1474825828.txt.gz · Last modified: 2016/09/25 17:50 by Lucas Hyland