User Tools

Site Tools


operations:agenda2017_03_16

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
operations:agenda2017_03_16 [2017/03/16 02:04]
Lucas Hyland
operations:agenda2017_03_16 [2017/03/16 02:27] (current)
Lucas Hyland
Line 16: Line 16:
   - Module at Hobart full or broken, but second module had key switched off   - Module at Hobart full or broken, but second module had key switched off
   - DBBC at Ke been playing up quite a few times over the last fortnight.   - DBBC at Ke been playing up quite a few times over the last fortnight.
 +  - Tsys at Yg not working, new hardware on the way to hopefully fix.
 +  - Ke cross over switch default setting. Needs attention.
 +
 +  - Did you know: new clean page.
 +  - Experiment name changed (e.g.) AUA003 instead of 002, make sure cal and master schedule are the same.
 +  - Ross-ter to clean kitchen.
    
 **Handover notes issues:** **Handover notes issues:**
   - A few problems with *R1780*:   - A few problems with *R1780*:
       - Hb e-remote control didn't work and neither did Dave's backup? Was this resolved and so what was the fix?       - Hb e-remote control didn't work and neither did Dave's backup? Was this resolved and so what was the fix?
-      - Ke DBBC problem? Is that resolved? +      - Ke DBBC problem? Is that resolved? ​PCI7200 BOARD. Replaced. 
-      - Patrick could you put the problem/fix you had with Ke IF power levels? Also the pointing problem and fix?+      - Patrick could you put the problem/fix you had with Ke IF power levels? Also the pointing problem and fix? Ped lost power and tripped E-stop. Needed manual reboot.
       - Bryn/Tiege, there were MK5 and clock problems at Yarragadee? The fix as per the handover notes seems vague.       - Bryn/Tiege, there were MK5 and clock problems at Yarragadee? The fix as per the handover notes seems vague.
   - *R1782*: ​   - *R1782*: ​
       - Ross I had the same problem with multiple dim's running. After I logged in as root (su) and tried that seemed to kill them.       - Ross I had the same problem with multiple dim's running. After I logged in as root (su) and tried that seemed to kill them.
-      - Could you please describe how you noticed/​diagnosed that the Mark5 disk/Mark5 was faulty at Hb? 'acs problem seems to be related to testing other module.'?​+      - Could you please describe how you noticed/​diagnosed that the Mark5 disk/Mark5 was faulty at Hb? 'acs problem seems to be related to testing other module.'? ​Didn't allow recording. Checkmk5 gave an error, scan_check 4/8th line gave a fault message. Swapped to other bank and back then it died. Module marked as bad.
   - *R4781*:   - *R4781*:
-      - "IF unit has a fault, probably with the PIC. No noise diode control at the moment, so no Tsys. Power levels into DBBC are OK though. (Jim)'"​ This was fixed already unless I am mistaken?+      - "IF unit has a fault, probably with the PIC. No noise diode control at the moment, so no Tsys. Power levels into DBBC are OK though. (Jim)'"​ This was fixed already unless I am mistaken? ​IF unit works apart from noise diode control, can't measure tsys. New pic on the way. 
   - *R4782*:   - *R4782*:
       - Secondary module not correctly inserted into mk5 (I think the key was not turned). When first module became full the the mk5 gave "ERROR m5 -900 : Can't XLRappend() recording"​ (which is not an alarm) until noticed at 17:00UT. I changed M5 -900 to ALARM in the alarm_actions.txt for Hb.       - Secondary module not correctly inserted into mk5 (I think the key was not turned). When first module became full the the mk5 gave "ERROR m5 -900 : Can't XLRappend() recording"​ (which is not an alarm) until noticed at 17:00UT. I changed M5 -900 to ALARM in the alarm_actions.txt for Hb.
-  ​- If people aren't using Arwins comments.py script, they should be. +      -  
 +  ​- If people aren't using Arwins comments.py script, they should be
 +        - Report problems.
  
  
  
/home/www/auscope/opswiki/data/pages/operations/agenda2017_03_16.txt · Last modified: 2017/03/16 02:27 by Lucas Hyland