User Tools

Site Tools


operations:documentation.rapidsetup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

operations:documentation.rapidsetup [2011/10/26 06:37] (current)
Line 1: Line 1:
 +**DBBC**
  
 +Go to the DBBC terminal on the KVM (switch position is 2) or open a VNC session to the DBBC with :
 +
 +<​code>​
 +vncviewer -shared 131.217.63.248:​0
 +</​code>​
 +
 +After editing the proc file, it is necessary to set up the DBBC and Mark5B. The C:​\DBBC_CONF\dbbc_config_file.txt has been edited to set the frequencies correctly for R1/R4 type experiments. For other experiments,​ the DBBC frequencies can be calculated either from the sky frequencies or from the original values of the VCs in the proc file. The sky frequencies are given in the skd file. To convert the VC frequency settings to DBBC frequencies you need to add 480 MHZ for the first 4, add 980.1 for dbbc05-dbbc08,​ add 120 for dbbc09-dbbc14 and set dbbc15 and dbbc16 to something innocuous (say, 320 MHz) as they'​re not being recorded. Running C:​\DBBC_CONF\DBBC Control.190710.exe and answering yes to configure the system should load the frequencies correctly. One the configuration is complete, you need to set up the IF system. The commands to do this are 
 +
 +dbbcifa=1,​agc,​1\\
 +dbbcifb=4,​agc,​4\\
 +dbbcifc=2,​agc,​2\\
 +dbbcifd=2,​agc,​2
 +
 +It appears that CoMo 3 is reporting low total power levels. It may be that there is a poor connection on one of the SMAs...The target values for the total power readings is 56000. this can be checked by the command dbbcif[abcd]. If the levels are too high or low, then adjust the attenuation on the IF box.
/home/www/auscope/opswiki/data/pages/operations/documentation.rapidsetup.txt · Last modified: 2011/10/26 06:37 (external edit)