User Tools

Site Tools


operations:minutes2014_08_06

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
operations:minutes2014_08_06 [2014/08/08 00:15]
liza
operations:minutes2014_08_06 [2014/08/08 00:23] (current)
liza
Line 11: Line 11:
  The recent AUSTs experiments are still awaiting correlation and will be reviewed as soon as available. Remasks: ​  The recent AUSTs experiments are still awaiting correlation and will be reviewed as soon as available. Remasks: ​
   *  Pointing: pointing offset should be <0.02 degree. If more, investigation should be done asap. Start the pointing procedure if time permits (to check pointing in other directions),​ log the offset & inform on-call person. If pointing fit repeatedly doesn'​t converge, dBBC is a likely culprit, especially at Yg.   *  Pointing: pointing offset should be <0.02 degree. If more, investigation should be done asap. Start the pointing procedure if time permits (to check pointing in other directions),​ log the offset & inform on-call person. If pointing fit repeatedly doesn'​t converge, dBBC is a likely culprit, especially at Yg.
-  *  RFI: if autocorrelation amplitudes look strange, it is likely to be caused by RFI, especially in the two last channels in the S band in Hobart. ​Report ​it. +  *  RFI: if autocorrelation amplitudes look strange, it is likely to be caused by RFI, especially in the two last channels in the S band in Hobart. ​Please report ​it. 
   *  Windstow: a substantial amount of data is lost due to an antenna that get stuck in the windstow position after the wind calms down, please check the anemometer when stow is reported. How to get the antenna out of the stow:    *  Windstow: a substantial amount of data is lost due to an antenna that get stuck in the windstow position after the wind calms down, please check the anemometer when stow is reported. How to get the antenna out of the stow: 
  
Line 32: Line 32:
  
 One may also need to open VNC session on timepc and manually switch drived off and on in HMI.  One may also need to open VNC session on timepc and manually switch drived off and on in HMI. 
 +  * Please advice the local staff at the observatory to mark dedicated module with the red dot sticker BEFORE the experiment strts to prevent erasing of a recorded module. The experiment name label should be glued on after the experiment.
 +
 +3. 
 +  * Handover notes are changed into the blog mode
 +  * Update of "​Current issues"​ will be done every two weeks after analysis of handover notes and search for recurrent problems
 +  * Observer should copy the handover notes into the "​Comment"​ session of the last checklist
 +  * Additional meeting to be called next week 
  
/home/www/auscope/opswiki/data/pages/operations/minutes2014_08_06.txt · Last modified: 2014/08/08 00:23 by liza