Differences

This shows you the differences between two versions of the page.

--- hardware:ups [2021/07/29 17:00]
Jamie McCallum
+++ hardware:ups [2022/04/21 14:20]
Warren Hankey [Mixed Mode Setup]
@@ Line 1: / Line 1: @@
 The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS.
-The main use at the moment is to power cycle the DBBC3HB - its UPS is currently connected to ''weather''.
+The main use at the moment is to power cycle the DBBC3s at both Mt. Pleasant and Katherine.
+===== Check Setup=====
+  Ensure RfSwOnForS is turned ON at pduhb and ipske  for mixed mode observations AUM, AUA etc
+  Otherwise wide band mode is enabled , symptoms include reported bad delays on IF's
+====== Hobart12 ======
 To reboot DBBC3HB, use the following commands <code>ssh observer@weather
 su
@@ Line 12: / Line 19: @@
 The ''upscmd'' will prompt for a username and password (''admin'' and the root pw.)
-If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start''
+====== Katherine ======
+To reboot DBBC3KE, use the following commands <code>ssh observer@dell2ke
+su
+upscmd  UPS-DBBC3 load.off
+### wait 10s
+upscmd  UPS-DBBC3 load.on
+</code>
+The upscmd will prompt for a username and password (admin and the root pw.)
+If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start'' . If that doesn't kill the running nut command, then restart the nut server with "/etc/init.d/nut-server restart"
 ====== Installation ======
 apt-get install nut
-Then edit the /etc/nut/ files - vc0/flexbuffhb have templates for a working configuration
+Then edit the /etc/nut/ files - vc0/flexbuffhb/dell2ke have templates for a working configuration
 ===== UPS interaction and control =====