Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
hardware:ups [2021/07/29 17:00]
Jamie McCallum
hardware:ups [2022/04/22 09:26]
Warren Hankey [Check Setup]
Line 1: Line 1:
 The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS.  The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS. 
  
-The main use at the moment is to power cycle the DBBC3HB - its UPS is currently connected to ''weather''.+The main use at the moment is to power cycle the DBBC3s at both Mt. Pleasant and Katherine.
  
 +====== Check Basic Setup======
 +
 +  Ensure RfSwOnForS is turned ON at pduhb and ipske  for mixed mode observations AUM, AUA etc
 +  
 +  Otherwise wide band mode is enabled, where symptoms include reported bad delays on IF'
 +
 +====== Hobart12 ======
 To reboot DBBC3HB, use the following commands <code>ssh observer@weather To reboot DBBC3HB, use the following commands <code>ssh observer@weather
 su su
Line 12: Line 19:
 The ''upscmd'' will prompt for a username and password (''admin'' and the root pw.) The ''upscmd'' will prompt for a username and password (''admin'' and the root pw.)
  
-If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start''+====== Katherine ====== 
 +To reboot DBBC3KE, use the following commands <code>ssh observer@dell2ke 
 +su 
 +upscmd  UPS-DBBC3 load.off 
 +### wait 10s 
 +upscmd  UPS-DBBC3 load.on 
 +</code> 
 +The upscmd will prompt for a username and password (admin and the root pw.) 
 + 
 +If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start'' . If that doesn't kill the running nut command, then restart the nut server with "/etc/init.d/nut-server restart" 
 + 
 + 
 ====== Installation ====== ====== Installation ======
 apt-get install nut apt-get install nut
  
-Then edit the /etc/nut/ files - vc0/flexbuffhb have templates for a working configuration +Then edit the /etc/nut/ files - vc0/flexbuffhb/dell2ke have templates for a working configuration 
  
 ===== UPS interaction and control ===== ===== UPS interaction and control =====