Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
hardware:ups [2021/10/19 13:59]
Jamie McCallum
hardware:ups [2022/04/22 09:26]
Warren Hankey [Check Setup]
Line 1: Line 1:
 The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS.  The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS. 
  
-The main use at the moment is to power cycle the DBBC3s at both Mt. Pleasant and Katherine. +The main use at the moment is to power cycle the DBBC3s at both Mt. Pleasant and Katherine. 
 + 
 +====== Check Basic Setup====== 
 + 
 +  Ensure RfSwOnForS is turned ON at pduhb and ipske  for mixed mode observations AUM, AUA etc 
 +   
 +  Otherwise wide band mode is enabled, where symptoms include reported bad delays on IF'
  
 ====== Hobart12 ====== ====== Hobart12 ======
Line 14: Line 20:
  
 ====== Katherine ====== ====== Katherine ======
-To reboot DBBC3KE, use the following commands <code>ssh observer@flexbuffke+To reboot DBBC3KE, use the following commands <code>ssh observer@dell2ke
 su su
 upscmd  UPS-DBBC3 load.off upscmd  UPS-DBBC3 load.off
Line 20: Line 26:
 upscmd  UPS-DBBC3 load.on upscmd  UPS-DBBC3 load.on
 </code> </code>
 +The upscmd will prompt for a username and password (admin and the root pw.)
  
-If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start''+If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start'' . If that doesn't kill the running nut command, then restart the nut server with "/etc/init.d/nut-server restart"