Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
hardware:ups [2021/07/29 17:00]
Jamie McCallum
hardware:ups [2022/04/22 09:26] (current)
Warren Hankey [Check Setup]
Line 1: Line 1:
 The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS.  The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS. 
  
-The main use at the moment is to power cycle the DBBC3HB - its UPS is currently connected to ''weather''.+The main use at the moment is to power cycle the DBBC3s at both Mt. Pleasant and Katherine.
  
 +====== Check Basic Setup======
 +
 +  Ensure RfSwOnForS is turned ON at pduhb and ipske  for mixed mode observations AUM, AUA etc
 +  
 +  Otherwise wide band mode is enabled, where symptoms include reported bad delays on IF'
 +
 +====== Hobart12 ======
 To reboot DBBC3HB, use the following commands <code>ssh observer@weather To reboot DBBC3HB, use the following commands <code>ssh observer@weather
 su su
Line 12: Line 19:
 The ''upscmd'' will prompt for a username and password (''admin'' and the root pw.) The ''upscmd'' will prompt for a username and password (''admin'' and the root pw.)
  
-If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start''+====== Katherine ====== 
 +To reboot DBBC3KE, use the following commands <code>ssh observer@dell2ke 
 +su 
 +upscmd  UPS-DBBC3 load.off 
 +### wait 10s 
 +upscmd  UPS-DBBC3 load.on 
 +</code> 
 +The upscmd will prompt for a username and password (admin and the root pw.) 
 + 
 +If you have error messages when running these commands, try killing any NUT processes (with ''pkill -9 nut'') and then restart with ''/etc/init.d/nut-server start'' . If that doesn't kill the running nut command, then restart the nut server with "/etc/init.d/nut-server restart" 
 + 
 + 
 ====== Installation ====== ====== Installation ======
 apt-get install nut apt-get install nut
  
-Then edit the /etc/nut/ files - vc0/flexbuffhb have templates for a working configuration +Then edit the /etc/nut/ files - vc0/flexbuffhb/dell2ke have templates for a working configuration 
  
 ===== UPS interaction and control ===== ===== UPS interaction and control =====