Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
hardware:ups [2021/10/27 09:47] Warren Hankey [Katherine] |
hardware:ups [2022/04/22 09:26] (current) Warren Hankey [Check Setup] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS. | The NUT control software is installed at a few sites and can be used to directly control Cyberpower and UPSonic UPS. | ||
| - | The main use at the moment is to power cycle the DBBC3s at both Mt. Pleasant and Katherine. | + | The main use at the moment is to power cycle the DBBC3s at both Mt. Pleasant and Katherine. |
| + | |||
| + | ====== Check Basic Setup====== | ||
| + | |||
| + | Ensure RfSwOnForS is turned ON at pduhb and ipske for mixed mode observations AUM, AUA etc | ||
| + | |||
| + | Otherwise wide band mode is enabled, where symptoms include reported bad delays on IF' | ||
| ====== Hobart12 ====== | ====== Hobart12 ====== | ||
| Line 14: | Line 20: | ||
| ====== Katherine ====== | ====== Katherine ====== | ||
| - | To reboot DBBC3KE, use the following commands < | + | To reboot DBBC3KE, use the following commands < |
| su | su | ||
| upscmd | upscmd | ||
| Line 22: | Line 28: | ||
| The upscmd will prompt for a username and password (admin and the root pw.) | The upscmd will prompt for a username and password (admin and the root pw.) | ||
| - | If you have error messages when running these commands, try killing any NUT processes (with '' | + | If you have error messages when running these commands, try killing any NUT processes (with '' |